DIY Welding Table

04 Aug.,2022

 

3D Welding Table

1. Align the 45 degree cut 2.5x1.5 inch square hollow metal bars into 2 sets of rectangles with the 125cm bars as the length and 75cm bars as the width. Use the set square to ensure 90 degree corners. Weld and fill in the gaps.

2. On one set of the rectangle, add the 63cm 2.5x1.5 inch square hollow metal bar vertically in the middle for added support of the structure. Use a spirit level to ensure that the surface is flat before welding. This rectangle will be the bottom piece of the table.

3. Set a 75cm 1.5x1.5 inch square hollow metal bar on each corner of the rectangle from the previous step. Use spirit levels to ensure that the bar is leveled before welding, as shown in the picture.

4. Add the second rectangle on top of the structure from the previous step and fully weld them together.

5. Flip the structure with the bottom facing upwards and place the caster wheels on each corner of the bottom. Weld them in place. It should look like as shown in the picture.

6. Again, add the 110cm 2.5x1.5 inch square hollow metal bar horizontally in the middle of the top rectangle piece as shown in the picture and weld it in place. Make sure that it is leveled with the top frame as this is where the flat metal bars will be placed and resting on.